Successfully pass the free certification exam at IW Academy and become an Infinet Certified Engineer.
Preliminary wireless devices configuration
To perform the alignment, it is necessary to pre-configure the Infinet wireless device, it includes the following steps:
NOTE
The alignment procedure via the InfiPOCKET assume its direct network interaction with any of the two wireless devices. The second will be accessed through the device to which the mobile application is directly connected.
- Network connection: the device must have the configuration necessary for network connection of a smartphone with InfiPOCKET to a wireless device, according to one of the connection schemes.
- SNMP: SNMP protocol support of any version must be enabled on the device, access credentials must be configured.
- Wireless link: the radio settings must be pre-configured on both devices.
- Additional conditions: follow the instructions for alignment of the corresponding families devices:
Profiles configuration in InfiPOCKET
To obtain the data required for alignment, an SNMP profile must be created in the InfiPOCKET application with SNMP settings match to the wireless device.
- Proceed to the "SNMP Profiles" section of the main menu. Click the "Create SNMP Profile" button.
- Fill in the form with SNMP profile parameters. The values must match the device's settings to which you are connecting:
- Arbitrary profile name.
- SNMP version.
- Access credentials.
- Click the "Save SNMP Profile" button.
Alignment
To start the alignment, connect to a wireless device via SNMP, using following procedure:
- In the "Alignment" section, fill out the connection form:
- wireless device IP address.
- network port used for SNMP connection.
- SNMP profile of the local device.
- SNMP profile of the remote device, by default the profile set for the local device is used.
- Click the "Connect" buttom.
- Confirm the wireless device was pre-configured and proceed to the alignment step.