R5000-Mmxb / R5000-Qmxb
R5000-Omxb
R5000-Qmxb, R5000-Mmx and R5000-Omx models have two LED indicators (red and green) located in the Console connector. These LEDs are useful in monitoring the device status during the installation procedure. LEDs modes and Device status correspondence is shown in the following table.
| Red indicator | Green indicator | Device status |
|---|---|---|
| Off | Off | Device is switched off of in the process of start-up booting |
| Off | Blinking | Device is booted. No radio connection. Searching for another device to establish radio connection to |
| Blinking | On | Radio connection established. The more data is transmitted through the radio channel the more frequently red indicator is blinking |
R5000-Smnb / R5000-Smn
R5000-Lmnb / R5000-Lmn
R5000-Smnc
R5000-Smnb, R5000-Smn, R5000-Smnc, R5000-Lmnb and R5000-Lmn models have a special LED indicator set located at the back of each device designed to provide basic status information.
| LED | Status | Device Status |
|---|---|---|
| PWR | On | The device is powered on |
| RF | Blinking | RF-link is being established |
| On | RF-link established | |
| ETH | On | Wired link established |
| Signal level | This scale displays current RF signal level and is designed to provide assistance in device alignment and link quality estimation. The scale is based on the SNR RX level, the threshold values for the indicator: 4, 8, 16, 30, 40 dB. The more often indicator flashes, the better quality of the connection. |