Infinet Wireless: Technical Documentation
Page tree

Versions Compared

Old Version 10

changes.mady.by.user Olga Kosareva

Saved on

compared with

New Version 11

changes.mady.by.user Tatyana Drazhnikova

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Center
Scroll Title
titleFigure - Switch section

Image RemovedImage Added

  • "Switch Port Settings" - allows you to perform general port configuration.
Center
Scroll Title
title Figure - Switch Port Settings

Image RemovedImage Added

Center
Scroll Title
titleTable - Port parameters
ParameterDescription
Up
  • You can enable or disable the port status
Egress Rate Limit
  • You can set the limit (traffic shaper) on the selected port, for outgoing traffic, in Mbps, from 1 to 100 in increments of 1, from 100 to 1000 in increments of 10, or to set it unlimited
QoS mode
  • You can select the traffic shaper policy for the port, WRR is selected by default
    • “Weighted Round Robin” - weights are used for every queue of an interface, which allows different queues to have different service shares depending on the weight value
    •  “Strict” - packets within lower priority queue are not processed if the higher priority queue is not empty
Port Mode
  • You can select the physical port operational mode from:
    • auto: the speed and operational mode of the port will be negotiated between the 2 end points
    • 10BaseT-halfduplex;10BaseT-halfduplexmanual; 10BaseT-fullduplex;10BaseT-fullduplex-manual
    • 100BaseTX-halfduplex; 100BaseTX-halfduplex-manual; 100BaseTX-fullduplex; 100BaseTX-fullduplex-manual
    • 1000BaseTX-fullduplex;1000BaseTX-fullduplex-manual
Transparent Clock
  • You can enable or disable synchronization clock in accordance with Precision Time Protocol (IEEE 1588)
Note
titleNOTE

 Manual settings for the "Port Mode" will disable the negotiation and detection for speed and duplex. Use them in case that the interconnected 3rd party switches have fixed speed and duplex settings.

...

Note
titleNOTE

The "Default VLAN" is configured by default as «Untagged» for all ports of the switch:

  • In case the "VLAN-based Switching"  is enabled, only untagged traffic will be transmitted through the unit ports in such configuration.
  • In case the "VLAN-based Switching"  is disabled, tagged and untagged traffic will be transmitted through the unit ports. In this case, the connectivity matrix between external interfaces and mgmt interface are enabled, device will be available through any of assigned IP addressess.

"Default VLAN" could not be deleted.

...