...
These parameters are used for identification and link authorization.
Center |
---|
Scroll Title |
---|
title-alignment | center |
---|
title | Unit parameters description |
---|
| Parameter | Description |
---|
Device Name | The arbitrary wireless unit name which will be used by network administrators for unit identification. It will be shown in Web GUI side panel. | Link ID | Wireless link identificator used to avoid connecting a unit to a wrong peer if there are several co-located units using the same center frequency. Specify different ID values for different links. Both ends of the same link must have the same ID. |
|
|
Center |
---|
Scroll Title |
---|
title | Figure - Unit parameters |
---|
| Image Removed |
|
Regulatory domain
Regulatory domain automatically limits the wireless device operation which is may be needed to meet the local law requirements. Each regulatory domain may limits the following parameters:
...
| scroll-title | title | Figure - Regulatory domain settings |
---|
| Image Removed | Image Added |
|
SNTP
Starts the SNTP time synchronization service. For proper operation, specify the SNTP server time zone and the IP address first. By default, the SNTP service is disabled.
Center |
---|
Scroll Title |
---|
title-alignment | center |
---|
title | SNTP parameters description |
---|
| Parameter | Description |
---|
SNTP Server Address
| The SNTP server IP address, the SNTP service will synchronize the time on the device with. The device must have network access to the SNTP server. | Time Zone
| The time zone at the place of device installation. For example: GMT + 5. |
|
|
Center |
---|
Scroll Title |
---|
title-alignment | center |
---|
title | Figure - SNTP settings |
---|
|
|
|
Syslog
Allows to transmit syslog data to the server using the "syslog" protocol. Specify the syslog server address where data should be transmitted.
Center |
---|
Scroll Title |
---|
title-alignment | center |
---|
title | Figure - Syslog configuration |
---|
| Image Added |
|