Page History

Interface

• Displays all physical and logical set interfaces 

• Displays the MAC address of each interface

• Displays for each interface whether it is “up and running” or not

• Displays the operation mode of each interface. For example
  • Ethernet interface: 
    • 10,100 or 1000 Mbps
  and half
  • • ;
    • Half or full duplex
  for the Ethernet interface
• Bitrate, frequency and bandwidth for the Radio interface, DFS status
• Switch Group number for the SVI
  • mode - red value of this parameter informs that transmission is performed in a half-duplex mode.
• Radio interface:
  • Bitrate;
  • Operating frequency - red value of this parameter indicates an absence of data transmission due to the spectrum scanning by the DFS tool;
  • Channel width;
  • TX Power - red value for this parameter may indicate a problem with the transceiver's hardware.;
  • DFS tool state;
  • Greenfield mode.
• SVI:
  • Switch group number.
• PRF interface:
  • Parent;
  • Channel number;
  • Frame size - red value of this parameter means impossibility to set the optimal size due to external limitation (MTU value on the switch port).
• Vlan interface:
  • Parent;
  • Vlan ID;
  • Selected vlan interface operation standard.

• Displays the number of received and transmitted packets for each interface since the unit is operational. The local system packets are counted, too (and not only the ones that are passing through the switching groups - data traffic)

• Displays the number of received and transmitted error packets for each interface since the unit is operational

• Displays the packet flow through each interface in real-time (for the system and the data traffic)