...
The "Network Access" page allows you to perform general networking configuration settings and it is divided in the following two sections:
- "Network settingsSettings" - allows you to configure the IP address of the unit, to specify a VLAN ID to pass and to enable or disable the DHCP for the IP address allocation. Multiple IP addresses can be added
| Center |
|---|
| Scroll Title |
|---|
| title | Figure - Network settings sectionSettings |
|---|
|  Image Removed Image Added
|
|
- "Routing parametersSettings" - allows you to configure the routing information for the unit. You can input the default gateway IP address and add a route to a specific destination by specifying the destination network address, the network mask and the gateway for reaching the destination
| Center |
|---|
| Scroll Title |
|---|
| title | Figure - Routing parametersSettings |
|---|
| Image Removed Image Added |
|
| Note |
|---|
|
Read the information at the section Apply and Try buttons for the configuration in order to find out the output of the «Apply», «Try» and buttons for the new configuration performed. |