...
Hide_comments |
---|
Table of Contents |
---|
Configuration analysis
In the web interface go to the section "Device status" → "Link statistics on rf5.0 interface", then left-click on the device to which the access is missing. Select the "Remote commands".
Center | |||||
---|---|---|---|---|---|
|
In the pop-up window enter the "config show". If the devices are configured via telnet, access to the remote device can be obtained with the "mint rf5.0 rcmd" command.
"Vlan" interfaces
Make sure the "vlan" interfaces are configured in accordance with the company's security policy (see point 1 at in the figure below). The VLAN configuration process using the command line is described in the "VLAN configuration" article.
Filtering rules
Pay attention to the traffic filtering rules in the switch group and in the "IPFirewall" subsection (point 2).
Center | |||||
---|---|---|---|---|---|
|
Checking
...
the switch settings on the remote device
...
Device management
Make sure that the switch group for device management is configured correctly (see point 3 at in the figure above). To access the device via the radio interface, the rf5.0 interface must be added to the management switch group. The svi interface must be associated with the switch group, the . The interface can be associated by using the "svi" command (point 4). The device's management IP address must be assigned to the svi interface using the "ifconfig" command (point 1). Switch The switch groups are configured by using the "switch" command.
...
Checking the members of the switch group
To display information about devices included in the switch groups, use the "mint rf5.0 map swg" command.
Center | |||||
---|---|---|---|---|---|
|
Switch statistics
To display statistics on about the dropped/blocked MAC addresses for each switch group, use the "switch statistics" command.
Center | |||||
---|---|---|---|---|---|
|
Checking
...
the switch settings on the local device
...
Device management
Make sure , that the switch group ID designed assigned for management on the local device matches with the switch group ID on the remote device. Make sure that the rf5.0 interface has been added to the switch group, the . The svi interface is associated with the switch group , which and its IP address is used for device management. For detailed information about the device management configuration proceed to the "Remote management of the R5000 units" article.
Filtering rules
Pay attention to the traffic filtering rules in the switch group and in the "IPFirewall" subsection. Make sure that the traffic from the remote device is not restricted.