...
LED indicators on the InfiMAN Evolution family base station sectors are located in the the cable glands ports. These indicators help to monitor the device's status during the installation. The correspondence between the state of the indicators and the current device state is shown in the table below.
Center | ||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Center | |||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
InfiMAN Evolution Subscriber Terminals and InfiLINK Evolution devices
InfiMAN Evolution ST and InfiLINK Evolution devices have a LED indicator set located at the back of each device, displaying the current device state.
Center | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
PWR - power indicators will light red when the device is connected to a power source, yellow when 10/100 Mbps wired connection appears and green when 1000 Mbps wired connection appears. Other indicators are used to perform coarse antenna alignment. The more indicators are on, the better wireless connection is established. The blinking indicator means an intermediate state. The more often the indicator blinks the higher level connection is established.
...
The factory reset process using the ERConsole is described in the "Emergence Repair Console" article.
Center | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Checking the status of the Ethernet interface
...
If you were able to access the device by connecting directly, try to determine the possible reason for the unavailability through the network. Pay attention to the wired interface statistics. In order to do this, go to the "Device status" section of the web interface and open the "General statistics" window for the Ethernet interface in the "Interface statistics" section. Pay attention to the CRC errors number, as they indicate a violation of the data integrity during the transmission over the wired segment. Also, the problem can be caused by a queue overflow (Retransmit limit) or an inappropriate frame size (Out of rangeLength errors).
Center | |||||||
---|---|---|---|---|---|---|---|
|
The description of the parameters for a complete diagnostic is available in the "Device status" article.
...
Pay attention to the duplex mode on the network devices connected to the wireless router. This information is available in the the web interface. Proceed to the "Device status" section - "Interface statistics" and open the "General statistic" for the Ethernet interface, or run the "ifconfig eth0" command in the command line interface.
Center | |||||||
---|---|---|---|---|---|---|---|
|
We recommend to set the auto-negotiation mode provided by the Ethernet standard. The problem can occur due to the connection between two devices with different duplex settings. For example, if one device is in auto-negotiation mode and the other is in fixed full duplex mode.
Red value of this parameter in the interface statistics "Mode" column informs that transmission is performed in a half-duplex mode.