| Include Page | ||||
|---|---|---|---|---|
|
| Hide_comments |
|---|
Cable gland assembly for R5000-Mmx/Mmxb/Omx/Omxb/Qmxb models
Required components:
- Unshielded RJ-45 connector
- Connector cover
- Shielded RJ-45 connector
- FTP Cat5e cable;
- Cable sealing nut
- Cable sealing grommet
- Cable gland case
- Cable gland nut
- Insert the sealing grommet (6) into the cable gland case (7) as shown on the picture
- Assemble the cable gland as shown on the picture by placing the cable gland nut (8) on the cable gland case (7)
- Put the cable sealing nut (5) and the cable gland assembly (7,8) onto the cable as shown on the picture
- Crimp the unshielded RJ-45 connector (1) onto the cable using the crimping tool
Pin-out scheme: T568B wiring standards
| Note | ||
|---|---|---|
| ||
The outside diameter value of the FTP Cat5e cable should not exceed 7 mm. |
| Note | ||
|---|---|---|
| ||
Do not use the shielded RJ-45 connector on this end of the cable as it should be attached on the IDU end. |
| Warning | ||
|---|---|---|
| ||
MAKE SURE THAT THE RJ-45 CONNECTOR IS WELL-CRIMPED. A LOOSE CONNECTOR CAN DAMAGE THE DEVICE. PLEASE NOTE THAT SUCH DAMAGE IS NOT COVERED BY THE WARRANTY. |
- Insert the cable gland assembly to the device socket
- Tighten the cable gland nut (8) until you hear a click by rotating it clockwise
- Tighten the cable sealing nut (5). Do not apply excessive force
Cable gland assembly for R5000-Smn/Lmn/Smnc models
Required components:
- FTP Cat5e cable
- Shielded RJ-45 connector
- Unshielded RJ-45 connector
- Cable sealing nut
- Cable gland case
- Put the cable sealing nut (4) and the cable gland case (5) onto the cable as shown on the picture
- Crimp the unshielded RJ-45 connector (3) onto the cable using the crimping tool
| Note | ||
|---|---|---|
| ||
The outside diameter value of the FTP Cat5e cable should not exceed 7 mm. |
| Note | ||
|---|---|---|
| ||
Do not use the shielded RJ-45 connector (2) on this end of the cable as it should be attached on the IDU end. |
| Warning | ||
|---|---|---|
| ||
Make sure that the RJ-45 connector is well-crimped. A loose connector can damage the device. Please note that such damage is not covered by the warranty. |
- Insert the connector into the socket until you hear a click
- Screw the cable gland case into the port and tighten it. Do not apply excessive force.
- Tighten the sealing nut (4). Do not apply excessive force.
Console cable connector soldering scheme
| Center | |||||
|---|---|---|---|---|---|
|
| Note | ||
|---|---|---|
| ||
A properly assembled cable gland seales against humidity. |