Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Supported hardware platforms: H05, H06, H07, H08, H11.
  2. It works only with MIMO devices.
  3. "transient" mode is not supported.
  4. It is recommended to use the same "TDMA" firmware version on all devices in the network.
  5. All synchronized master devices in sync mode with AUX-ODU-SYNC must have the following equal parameters: 
    • Frame Size
    • DL/UL ratio.
  6. There are the following conditions of "TDMA" use in various channel width:
    • Fully supported: 5, 10, 20, 40 MHz.
    • Operates, but there may be minor frame deviations: 3.5, 7, 30 MHz (with "Greenfield").
    • Not recommended for use: 14, 15, 30 MHz.
    • Fully inoperable: 28 MHz.
  7. Recommended channel width in PtMP topology: 20 and 40 MHz (this is due to large overhead for the service information transmission in narrow channel width). 

...

Note
titleNOTE

Information about hardware platform type is available in the section "Maintenance" -> "Firmware".

Note
titleNOTE

 "_upgrade -q" command is available starting with firmware version "MINTv1.90.17". It is recommended to install the firmware version not lower than "MINTv1.90.25" before the boot monitor upgrade. The command can be executed via a web interface in the section "Command Line".

...

Note
titleNOTE

In the case of synchronization with AUX-ODU-SYNC, please perform settings described in the section "Connection to the synchronization unit".