Infinet Wireless: Technical Documentation
Page tree

Versions Compared

Old Version 2

changes.mady.by.user Olga Kosareva

Saved on

compared with

New Version 3

changes.mady.by.user Olga Kosareva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Center
Scroll Title
titleTable - Port parameters
ParameterDescription
Egress Rate Limit
  • You can set the limit (traffic shaper) on the selected port, for outgoing traffic, in Mbps, from 1 to 100 in increments of 1, from 100 to 1000 in increments of 10, or to set it unlimited
QoS mode
  • You can select the traffic shaper policy for the port, WRR is selected by default
    • “Weighted Round Robin” - weights are used for every queue of an interface, which allows different queues to have different service shares depending on the weight value
    •  “Strict” - packets within lower priority queue are not processed if the higher priority queue is not empty
Port Mode
  • You can select the physical port operational mode from:
    • auto: the speed and operational mode of the port will be negotiated between the 2 end points
    • 10BaseT-halfduplex;10BaseT-halfduplexmanual; 10BaseT-fullduplex;10BaseT-fullduplex-manual
    • 100BaseTX-halfduplex; 100BaseTX-halfduplex-manual; 100BaseTX-fullduplex; 100BaseTX-fullduplex-manual
    • 1000BaseTX-fullduplex;1000BaseTX-fullduplex-manual
Up
  • You can enable or disable the port status
Note
titleNOTE

 Manual settings for the "Port Mode" will disable the negotiation and detection for speed and duplex. Use them in case that the interconnected 3rd party switches have fixed speed and duplex settings.

...

Center
Scroll Title
titleFigure - Connectivity matrix section example

  • "VLAN-based Switching" allows to create list of allowed VLANs and allowed VLANs and their handling on InfiLINK XG switch plane. Without such option active, wireless link works as transparent Layer2 Layer 2 bridge. Thus, the link transport any frames with any VLAN tags any VLAN tags set.
Center
Scroll Title
titleFigure - VLAN-based Switching section

The "Priority" field allows you to set the priority for the selected VLAN according to 802.1p ranging from 0 to 7, where 0 - the lowest priority level, 7 - the highest.