Page History

...

1. Unpack the equipment
2. Check items integrity
3. Prepare RF - cables of the required length. For 5GHz devices the recommended maximal RF cable length is 1 meter
4. Install and isolate the connectors on the RF cable

5. Determine the FTP the FTP cable length that is used to connect IDU and ODU. The total cable length between LAN (behind IDU) and ODU should not be longer than 100 meters. Service cable connecting IDU and ODU should be FTP Cat5E cableCat5e cable with the outside diameter value not more than 7mm.

   Center
   Scroll Title title Figure - Installation scheme

6. Install (solder) connector for ODU on the FTP cable and FTP cable and isolate it
7. If it is possible to lay FTP cable with cable with a connector on the IDU side, install (solder) connector for IDU on the FTP cable and cable and isolate it
8. Lay the FTP cable “from cable “from top to bottom” – from ODU to IDU
9. If step 7 is not accomplished, after the FTP cable has cable has been laid, install (solder) connector for IDU
10. Install ODU on the mounting bracket connectors down and tighten it
11. Connect the ODU-IDU cable to the ODU
12. Isolate the ODU connector joint place
13. Once the antenna and antenna pole are installed they must be grounded via lightning protection grounding contour. Antenna’s position must be lower than the highest antenna pole point at least by 2 antenna heights. If antenna is NOT DC-shorted (see antenna technical documentation), the additional lightning arrestor protection unit must be used which is placed between ODU and antenna and is grounded to the antenna pole grounding contour.
14. Connect RF cable to the antenna. Twist the connector tightly
15. Connect RF cable to the ODU previously having touched RF cable connector case with ODU connector case

16. Isolate RF connectors from both sides (ODU and antenna)

    Center
    Scroll Title title Figure - Connection scheme

17. Connect the FTP cable to cable to IDU previously having touched IDU connector case with FTP cable connector cable connector case
18. Provide grounding for IDU
19. Connect Ethernet cable to IDU
20. Provide power supply for IDU
21. Connect to the Router using Telnet protocol.