Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Center
Scroll Title
titleAir frame settings description
ParameterDescription
Channel width

Channel width, shoud be the same on both Master and Slave units.

Frame period

Frame period affects the following wireless link metrics:

  • The greater frame period the more payload will be transmitted in one frame. Greater values increase latency.
  • The lower frame period the less payload will be transmitted in one frame. Lower values decrease latency.

Please note that frame period value is strongly depends on interference conditions. If larger frames will be dropped then larger payload is lost and system performance is decreased significantly. If smaller frames will be dropped then smaller payload is lost and system performance is decreased not so significantly.

Guard interval

Guard interval is intended for intersymbol interference elimination. One of the causes of intersymbol interference is multipath propagation in which a wireless signal from a transmitter reaches the receiver via multiple paths. Guard interval affects payload size. So it should be increased only in case of intersymbol interference.

Uplink/Downlink ratio

Allows to configure quotes for uplink and downlink directions. Available values depend from:

  • Channel width.
  • Frame period.
Center
Scroll Title
titleFigure - Air frame settings

Image Added

Automatic modulation and transmit power control

Center
Scroll Title
titleAMC and ATPC settings description
ParameterDescription
AMC strategy

There are folowing AMC strategies are available:

  • Normal - represents a balance between the error rate and throughput values.
  • Conservative - assumes using higher CINR thresholds in order to minimize the error rate.
  • Agressive - lowers the thresholds in order to use higher modulation levels and thus increase the throughput.
Frame period

Frame period affects the following wireless link metrics:

  • The greater frame period the more payload will be transmitted in one frame. Greater values increase latency.
  • The lower frame period the less payload will be transmitted in one frame. Lower values decrease latency.

Please note that frame period value is strongly depends on interference conditions. If larger frames will be dropped then larger payload is lost and system performance is decreased significantly. If smaller frames will be dropped then smaller payload is lost and system performance is decreased not so significantly.

Guard interval

Guard interval is intended for intersymbol interference elimination. One of the causes of intersymbol interference is multipath propagation in which a wireless signal from a transmitter reaches the receiver via multiple paths. Guard interval affects payload size. So it should be increased only in case of intersymbol interference.

Uplink/Downlink ratio

Allows to configure quotes for uplink and downlink directions. Available values depend from:

  • Channel width.
  • Frame period.
Center
Scroll Title
titleFigure - Air frame settings

Image Modified