...
Automatic modulation and transmit power control
| Center |
|---|
| Scroll Title |
|---|
| title | AMC and ATPC settings description |
|---|
| | Parameter | Description |
|---|
| AMC strategy | There are folowing AMC strategies are available: - Normal - represents a balance between the error rate and throughput values.
- Conservative - assumes using higher CINR thresholds in order to minimize the error rate.
- Agressive - lowers the thresholds in order to use higher modulation levels and thus increase the throughput.
| | Automatic transmit power control | ATPC allows to automatically control transmitter output power. Each unit has its own target RSSI level value calculated automatically. If actual RSSI level is lower then unit increases transmitter output power of the ewmote unit and vice versa. ATPC could not set value that may exceed the "Power limit" value. - The Master unit manages the transmit power of Slave unit.
- The Slave unit manages the transmit power of Master unit.
|
|
|
| Center |
|---|
| Scroll Title |
|---|
| title | Figure - AMC and ATPC settings |
|---|
| 
|
|
Frequency channel grids
Each available channel width connected with appropriate channel grid. Grid is used for automatic selection of center frequency function and contains a list of frequencies can be switched to. In the example below you may see that wireless unit with enabled "Automatic selection of center frequency" may change center frequency to the following values (MHz): 5100, 5120, 5140, 5300, 5390, 5410.
| Center |
|---|
| Code Block |
|---|
| 5100-5140/20, 5300, 5390-5410/20 |
|
Each element of list may be set as follows:
- 5300 - exact value;
- 5100-5140/20, 5390-5410/20 - range of values with 20 MHz step, step always must correspond to channel width.
| Center |
|---|
| Scroll Title |
|---|
| title | Figure - Frequency channel grids |
|---|
| TBD |
|