Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

The limitations in InfiNet devices can be performed by the license which includes the set of frequencies used in the configuration and the presence of the radar detection option. A license may be issued in accordance with the regulations for a particular territory.

...

DFS

...

Алгоритм динамического выбора частоты состоит из следующих этапов:

...

  1. Для каждого частотного канала запоминается максимальный уровень сигнала и фиксируется в таблице DFS. Для исключения ложного срабатывания, при оценке уровня сигнала, также учитывается его спектральная плотность.
  2. По умолчанию длительность сканирование на каждом из частотных каналов составляет 3 секунды, этот параметр является настраиваемым.
  3. Общая продолжительность сканирования зависит от числа каналов в частотной сетке.

...

  1. Установление канала связи с абонентскими устройствами.
  2. Передача данных.

...

operation principles

The dynamic frequency selection algorithm consists of the following steps:

  1. Turn on the device.
  2. Sequential channel scanning in accordance with the frequency grid. The scanning result is a filled DFS table, in which each channel corresponds to the level of the detected interference signal.
    1. The maximum signal level for each frequency channel is recorded in the DFS table. To eliminate false positives, when assessing the signal level, its spectral density is also taken into account.
    2. By default, the scan duration on each frequency channel is 3 seconds, this parameter is configurable.
    3. The total scan duration depends on the number of channels in the frequency grid.
  3. Analyze the DFS table and select the frequency channel with the lowest signal level.
  4. Set the selected channel center frequency as the operating center frequency of the wireless device.
    1. Establishing a link with subscriber devices.
    2. Data transmission.
  5. After 24 hours, rescan and reselect the frequency (steps 2-4). User can manually set the re-scanning time.

Поясним алгоритм динамического выбора частоты на примере (см. видеоролик 1).

...