Page tree

Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.


  • Getting started” - This chapter presents the information about this document’s purpose and structure.
  • "Unit General Description" – this chapter contains general description of the unit and functions of its ports.

  • "Access to the unit via CLI" - this chapter provides information about access to the unit via CLI.
  • "Commands for modem configuration" – this chapter contains descriptions of the commands for enabling/disabling of radio interface and radio link parameters configuration:
    • Selection of node type (Master/Slave), setting of link distance and  channel width, downlink/uplink ratio configuration, settings of central frequencies and air frame period.
    • Selection of strategies for traffic prioritization and modulation scheme selection.
    • Getting statistics and device configuration review.
    • In addition, this chapter provides step-by-step guidelines for initial configuration of the devices, their installation and monitoring.
  • "Commands for switch configuration" – this chapter provides description of the commands that are used for switch configuration, as well as configuration examples. Descriptions include: selection of operation mode, VLAN, STP, QoS settings, switch statistics collection

  • "Commands for GPS/GLONASS-receiver configuration" – this chapter contains descriptions of the commands for the management by built-in GPS/GLONASS-receiver, which provide selection of trace level, GPS/GLONASS-receiver statistics and status
  • "Command for spectrum scanning" - this chapter contains description of the commands and options for Spectrum Analyzer starting
  • "Commands for diagnostic card creation" - this chapter contains the commands set for diagnostic card creation
  • "Other commands of the unit" - thia chapter contains frequently used commands.