Page tree
Skip to end of metadata
Go to start of metadata

Successfully pass the free certification exam at IW Academy and become an Infinet Certified Engineer.

To the certification exam

In the "Spectrum Analyzer" menu, you can perform a deep analysis of the radio emissions in the environment where the unit is placed. The unit scans the radio spectrum on all available frequencies. In order to obtain the information as accurate as possible, the scanning process may take a while.

Figure - Spectrum analyzer result

The following parameters are available in order to operate the Spectrum Analyzer:

ParameterDescription

Start Frequency

  • Set the first frequency for scanning (in MHz).

Stop Frequency

  • Set the last frequency for scanning (in MHz).
Scan step
  • Set the scanning frequency step (in MHz).
  • It is recommended to set 1 MHz “step” value to get more precise scanning results.

Channel width

  • Set the bandwidth (in MHz).

Scan Duration

  • Set the time period for the scanning process (in seconds).
  • After the end of this time period, scanning is stopped and the radio interface will be back to its normal mode operation.
Estimated scan time
  • Estimated scan duration.
Table - Spectrum analyzer parameters

Click on "Start scanning" button to start scanning. You may stop scanning by clicking on appropriate button.

By clicking the "Last Snapshot" button, you get the final scanning results. The most common usage of this feature is when you perform a spectrum scan at the remote unit on the other side of the wireless link. When running a spectrum scan at such a unit (accessible via the RF interface), connection to this unit will be lost for a scan time. "Last Snapshot" option allows viewing scan results when the connection gets up again.