Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Current »

Document structure

This document consists of the following chapters:

  • Getting started” - This chapter presents the information about this document’s purpose and structure.
  • "Unit General Description" – this chapter contains general description of the unit and functions of its ports.

  • "Access to the unit via CLI" - this chapter provides information about access to the unit via CLI.
  • "Commands for modem configuration" – this chapter contains descriptions of the commands for enabling/disabling of radio interface and radio link parameters configuration:
    • Selection of node type (Master/Slave), setting of link distance and  channel width, downlink/uplink ratio configuration, settings of central frequencies and air frame period.
    • Selection of strategies for traffic prioritization and modulation scheme selection.
    • Getting statistics and device configuration review.
    • In addition, this chapter provides step-by-step guidelines for initial configuration of the devices, their installation and monitoring.
  • "Commands for switch configuration" – this chapter provides description of the commands that are used for switch configuration, as well as configuration examples. Descriptions include: selection of operation mode, VLAN, STP, QoS settings, switch statistics collection

  • "Commands for GPS/GLONASS-receiver configuration" – this chapter contains descriptions of the commands for the management by built-in GPS/GLONASS-receiver, which provide selection of trace level, GPS/GLONASS-receiver statistics and status
  • "Command for spectrum scanning" - this chapter contains description of the commands and options for Spectrum Analyzer starting
  • "Commands for diagnostic card creation" - this chapter contains the commands set for diagnostic card creation
  • "Other commands of the unit" - thia chapter contains frequently used commands.


The following abbreviations are used in this document:

  • AMC - Automatic Modulation Control

  • CCTV - Сlosed Circuit Television

  • CINR - Carrier to Interference + Noise Ratio

  • CLI - Command Line Interface

  • DHCP - Dynamic Host Configuration Protocol

  • FDD - Frequency Division Duplexing

  • FTP - File Transfer Protocol

  • IP - Internet Protocol

  • IPTV - Internet Protocol Television

  • MAC - Media Access Control

  • RF - Radio Frequency

  • RSSI - Received Signal Strength Indicator

  • QoS - Quality of Service

  • SFP - Small Form-factor Pluggable

  • STP - Spanning Tree Protocol

  • TDD - Time Division Duplexing

  • UDP - User Datagram Protocol

  • VLAN - Virtual Local Area Network

  • WRR - Weighted Round Robin

Document marks


All caution warnings are marked with a special warning sign. One should pay a great deal of attention to what is written in the Caution section.


All notes are marked with a special note sign. Notes usually contain useful comments or hints to the described section of the document. 

  • No labels