Use this command to start the Spectrum Analyzer.

Syntax:

#1> xgscan [arguments]

#xgscan usage:
	xgscan -freq {<freq_start>[-<freq_end>[/<step>]],...}
	xgscan -duration {10...10000}
	xgscan -last
	xgscan -stream {V, H}
	xgscan -capabilities

Arguments description is given in the table below

CommandDescription

xgscan -freq {<freq_start>[-<freq_end>[/<step>]],...}

  • Fist (minimum) and last (maximum) frequency for scanning, scanning frequency step
  • It is recommended to set 1 MHz step value to get the more precise scanning results. Please note, the smaller the step, the more time it takes to scan. In order to detect the interference it is sufficient to set the step equal to the used bandwidth

xgscan -duration {10...10000}

  • Scanning duration of one frequency in milliseconds

xgscan -last

  • Final scanning results (stored until the reboot)

xgscan -stream {V, H}

  • Polarization:
    • "V" - vertical
    • "H" - horizontal

xgscan -capabilities

  • List of parameters available for using during scanning
    • "available freq" - available frequency range
    • "steps for web" - scanning frequency step for web-interface
    • "bands for web" - bandwidth for web-interface
    • "grid width" - bandwidth value for the highlighted frequency channel
    • "all available freq for use" - all available frequencies for use