The command is used to configure a radio interface. This document describes the command in WANFleX software version with TDMA technology support.
Not all of the radio interfaces have the same set of parameters and options because it depends on the radio module type and standard. A complete list of parameters available for the specific interface can be displayed by "rf interface ?" command. Radio module type and its features list are displayed by "rf interface cap" command. |
Syntax:
usage: rf interface parameters... Interface rf5.0 parameters: band XXX: bandwidth (MHz) grid B G: frequency grid - <bw> freq1[-freq2[/step]],... | clear freq XXX: central frequency (MHz) bitr XXX: bitrate (Kbps) txpwr XXX: tx power (dBm) sid XXX: system identifier - up to 8 hex digits [10101010] cap [full]: RF capabilities txrt XXX: max transmit retries [10] txvrt XXX: max transmit retries in voice mode [5] [-]burst : burst mode (Super Packeting) [-]shortgi: short guard interval mode [-]pwrctl : automatic TPC mode mimo|miso [-]misoctl [-]greenfield |
If frequency roaming is enabled, make changes to the roaming profile using "mint profile" command before making changes on the unit. |
|
Displays the radio module's parameters.
| |
Possible methods of how to set frequency grid are shown in the following example:
| |
Set the bandwidth value 20 on the node which use frequency roaming.
| |
Display the current radio module's statistic.
|