General recommendations

To perform a correct alignment via RSSI LED display, the automatic transmit power control mechanism (ATPC) must be disabled.

For further adjustment if needed weaken the nuts M8 on about 15 degrees. Perform required antenna alignment and then tighten nuts M8.

Do not adjust knobs without weaken the nuts first.

Alignment tool

Use the Alignment tool to point and optimize the device in the direction of maximum link signal. The built-in graphical antenna alignment tool displays the signal levels for both devices, this makes an alignment process fast and accurate.

A green marker indicates the current signal level. To achieve the best performance, this marker should be as close as possible to the pale green area values, which displays the maximum calculated value possible for this link. A gray marker indicates the maximum value that was reached on this channel.