View Source

Required components are listed below.

Unshielded RJ-45 connector.
Shielded RJ-45 connector.
FTP Cat5e cable.
Cable gland:
- Cable sealing nut.
- Cable sealing grommet with rubber seal.
- Cable gland case.
Crimping tool for RJ-45 connector.

The outside diameter value of the FTP Cat5e cable should not exceed 7 mm.

Assemble procedure

In order to ensure that the device case remains sealed under any environmental conditions follow the assemble procedure:

Step 1: Insert the sealing insert into the clamping claw.
Step 2: Assemble the cable gland by putting the thread-lock sealing nut, clamping claw with sealing insert and body onto the cable as shown on the figure.
Step 3: Insert the clamping claw with sealing insert into the body as shown on the figure.
Step 4: Crimp the standard RJ-45 connector onto the cable using crimping tool. Pin-out scheme: T568B wiring standards

Do not use the shielded RJ-45 connector on this end of the cable as it should be attached on the power supply unit end.

Make sure that the RJ-45 connector is well-crimped. A loose connector can damage the device. Please note that such damage is not covered by the warranty.

Step 5: Insert the Rj-45 connector into the device socket until you hear a click.
Step 6: Screw the cable gland body into the port and tighten it. Do not apply excessive force.
Step 7: Tighten the thread-lock sealing nut. Do not apply excessive force.