Pre-installation

Reqiered tools

Additional equipment

Before mounting the equipment in an outdoor environment, please make sure that

Quanta 5 Installation Procedure

  1. In case of device with external antenna. Prepare RF cables of the required length, recommended maximal length is 1 meter. Install and isolate the connectors on the RF cable.

    In order to prevent device damage make sure that antenna is connected to both N-type connectors with serviceable RF cables before switching on.

  2. Install ODU connector facing down using the MONT-KIT-85. Do not tighten the fasteners to the end until the alignment is completed.
  3. Connect the Cat5e FTP cable with the cable gland to ODU.
  4. Perform ODU grounding.
  5. Lay the Cat5e FTP cable from ODU to the power supply.
  6. Connect the Cat5e FTP cable with a shielded connector covered by a cap to the "OUT" port of the power supply, having previously touched the power supply connector case with FTP cable connector case.
  7. Perform the power supply grounding.
  8. Connect the laptop using Cat5e FTP cable to the power supply "IN" port.
  9. Connect the power cord to the power supply and then to the power circuit.

    Use mains supply cords that adhere to safety regulations of the country where the equipment is getting deployed.

Make sure a small loop (at least 10 cable diameters) is provided before the Cat5e FTP cable enter into the building.