Required components are listed below.
The outside diameter value of the FTP Cat5e cable should not exceed 7 mm. |
Cable gland can be assembled on pre-crimped cable. |
In order to ensure that the device case remains sealed under any environmental conditions follow the assemble procedure:
Do not use the shielded RJ-45 connector on this end of the cable as it should be attached on the power supply unit end. |
Make sure that the RJ-45 connector is well-crimped. A loose connector can damage the device. Please note that such damage is not covered by the warranty. |
Required components are listed below.
In order to disassemble SFP, please disconnect the optical cable, pull the clip of the SFP-module and withdraw the SFP-module from the slot. |
SFP module is not included into the packing list. |