...
| Center |
|---|
| Scroll Title |
|---|
| title | Figure - LED indication of R5000-Mmx, R5000-Qmx, R500-Omx devices |
|---|
| | Gliffy Diagram |
|---|
| displayName | Индикация H08 Copy |
|---|
| name | Индикация H08 Copy |
|---|
| pagePin | 2 |
|---|
|
|
|
| Center |
|---|
| Scroll Title |
|---|
| title | Table - LEDs modes and device status of R5000-Qmxb, R5000-Mmx and R5000-Omx models |
|---|
| | Red indicator | Green indicator | Device status |
|---|
| Off | Off | The device is switched off or in the process of start-up booting | | Off | Blinking | The device has booted, but it has no radio connection. Searching for another device to establish the radio connection | | Blinking | On | Radio connection established. The more data is being transmitted through the radio channel the more frequently the red indicator is blinking |
|
|
...
| Center |
|---|
| Scroll Title |
|---|
| title | Figure - LED indication of R5000-Smn, R5000-Lmn devices |
|---|
| | Gliffy Diagram |
|---|
| displayName | H11 индикация Copy |
|---|
| name | H11 индикация Copy |
|---|
| pagePin | 2 |
|---|
|
|
|
| Center |
|---|
| Scroll Title |
|---|
| title | Table - LED indicators modes and device status of R5000-Smn and R5000-Lmn models |
|---|
| | Indicator | Status | Device status |
|---|
| PWR | On | The device is powered on | | RF | Blinking | The RF-link is being established | | On | The RF-link is established | | ETH | On | Wired link established | | Signal level |
| This scale displays the current RF signal level and is designed to provide assistance for the radio link alignment and to estimate the link quality. The scale is based on the SNR RX level, with the threshold values for the indicator: 4, 8, 16, 30, 40 dB. The more often the indicator flashes, the better is the quality of the connection. |
|
|
...
| Center |
|---|
| Scroll Title |
|---|
| title | Figure - The recommended connection scheme |
|---|
| | Gliffy Diagram |
|---|
| displayName | Схема ERC R5000 Copy |
|---|
| name | Схема ERC R5000 Copy |
|---|
| pagePin | 2 |
|---|
|
|
|
Checking the status of the Ethernet interface
...
We recommend to set the auto-negotiation mode provided by the Ethernet standard. The problem can occur due to the connection between two devices with different duplex settings. For example, if one device is in auto-negotiation mode and the other is in fixed full duplex mode.
Red value of this parameter in the interface statistics "Mode" column means impossibility to set the optimal size due to external limitation (MTU value on the switch port).