...
Note | ||
---|---|---|
| ||
During the configuration of the devices in a lab, take into account the following requirements:
|
...
If the device does not have a radio interface, the reason for such behavior can be the recovery mode present during the reset of the device using the ERConsole. Complete the recovery process by returning the device to the factory settings in from the Maintenance section.
Checking the firmware version
...
In the "Maintenance" section, make sure that the same software version is installed on both devices: MINT or TDMA. Instructions for switching between the MINT and TDMA software versions are available in the article "How to upgrade your network from MINT to TDMA". We recommend to update the devices to the latest beta software version.
...
To upload the software via the command line, use the "flashnet" command described in the "General Purpose Command Set" article.
Checking
...
the installation requirements
Checking the network infrastructure
If the link is not established after the installation on site, make sure that the devices were not damaged during shipping, check the integrity of the network infrastructure, the cables and the power supplies.
Checking the installation requirements
Check if the suspension height, azimuth and elevation of the antenna match with the values obtained from InfiPLANNER. Make sure that the obstacles on the path profile are not higher than those specified during the planning phase.
...