...
Note |
---|
|
Read the information at the section Apply and Try buttons for the configuration in order to find out the output of the «Apply», «Try» and buttons for the new configuration performed. |
Center |
---|
Scroll Title |
---|
title | Figure - General page |
---|
| Image RemovedImage Added |
|
The general page is divided in the following sections:
- Access Credentials and Web GUIWeb GUI
Center |
---|
Scroll Title |
---|
title | Table - Access credentials and Web GUI |
---|
| General System Parameter | Description |
---|
Device Name | - You can set the device name
- This parameter is displayed in the web-page header
| Username | - Displays the username (Login) used to access the unit management interfaces
- You can change the current username
| Password and Confirm Password | - You can change the password set in the previous configuration only after unmarking the option “keep current system password" in the corresponding checkbox
- You can return to the default settings for "Password" and "User Name" (any values with non-zero length) by unmarking the checkbox “Keep current system password” and leaving the corresponding fields empty and save the configuration at the bottom of the page
| Guest Username | - You can set the guest user name for accessing the unit in guest mode.
- The user name and password in the previous fields for normal login should be specified first. If they are not specified, the guest user name will not take effect
- The guest mode allows access to the unit in a restrictive mode: only the device status can be seen and no configuration modifications are available
| WEB GUI language | - You can change the default system language (English) into Russian
| Keep current system password | - If this checkbox is unselected, you can set new credentials for accessing the unit, if checked, this option will keep the current login password in use
| Allow HTTPS only | - You can set that all HTTP connections to the unit to perform via HTTPS (HTTP with SSL only) by marking the option “Allow HTTPS only” in the corresponding checkbox
- By default, this option is disabled
|
|
|
- SNTP and SNTP and Time Zone
Center |
---|
Scroll Title |
---|
title | Table - SNTP and Time Zone |
---|
| General System Parameter | Description |
---|
Enable SNTP | - You can start SNTP service by marking the option “Enable SNTP” in the corresponding checkbox
- By default, this option is disabled
| SNTP Server Address | - You can set the IP address of a valid SNTP server
- The unit must have an active connection with the SNTP server in order to receive time services
| Time Zone | - You can set the time zone. For example, GMT+4
|
|
|
...