Page History

...

• Console port.
• Command line interface.
• Web interface.

Configuring via console port 

The device is equipped with an RJ45 console port to connect PC for configuration and management. In order to configure the device using console port, follow the below:

• Connect the console port to the PC serial port with the console cable.
• Check the PC serial port number. To do this, go to "Device Manager" → "COM and LPT ports". The
example uses the COM3 port (you may need to install drivers)
• drivers installation may be needed.
• Run any terminal emulation program (for example, PuTTY: https://www.putty.org/).

Image Modified

In order to configure the device using console port, follow the below:

...

...

• Select the serial port.

Image Added

• Go to the serial connection settings section, set the port characteristics to 38400 rate, 8 bits, 1 stop bit, parity off, flow control is disabled

...

• , and click "Open".

Image Added

If all above procedures are completed correctly, you will see the WANFleX OS prompt:

• Login.
• Password

Every new device has no initial login and password settings, so you can use any non-zero length login and password to enter the device.

After default authorization there will be standard console prompt: "console>". Now the device is ready for the initial configuration procedure.

Configuring via command line interface