| Include Page | ||||
|---|---|---|---|---|
|
| Hide_comments |
|---|
| Scroll Ignore | |
|---|---|
|
Cable Gland Assembly
Required components:
- FTP Cat5e cable category 5e;
- Shielded Unshielded RJ-45 connector;Unshielded
- Shielded RJ-45 connector;
- Cable gland nut;
- Split sealing grommet;
- Cable gland threaded coupling.
| Notenote | ||
|---|---|---|
| ||
The outside diameter value of the FTP Cat5e cable should not exceed 7 mm. |
| Note | ||
|---|---|---|
| ||
Cable gland can be assembled on pre-crimped cable. |
- Crimp the unshielded RJ-45 connector (32) onto the cable using the crimping tool.
Pin-out scheme: T568B wiring standards
| Note | ||
|---|---|---|
| ||
Do not use the shielded RJ-45 connector on this end of the cable as it should be attached on the IDU end. |
| Warning | ||
|---|---|---|
| ||
MAKE SURE THAT THE RJ-45 CONNECTOR IS WELL-CRIMPED. A LOOSE CONNECTOR CAN DAMAGE THE DEVICE. PLEASE NOTE THAT SUCH DAMAGE IS NOT COVERED BY THE WARRANTY. |
- Put the cable gland nut (4), the split sealing grommet (5) and the cable gland threaded coupling (6) onto the pre-terminated cable.
- Insert the split sealing grommet (5) into the cable gland threaded coupling (6).
- Insert the connector into the socket until you hear a click.
- Screw the cable gland threaded coupling (6) into the port and tighten it.
- Tighten the cable gland nut (4). Do not apply excessive force.
Cable Gland Assembly for Optical Cable
| Note | ||
|---|---|---|
| ||
SFP module is not included into the packing list. Is possible to use an SFP (Small Form-factor Pluggable) transceiver of any manufacturer that meets the MSA (MultiSource Agreement) standard. |
Required components:
- Optical cable
- Optical connector
- SFP-module
- Cable gland nut
- Split sealing grommet
- Cable gland threaded coupling.
- Put the cable gland nut (4), the split sealing grommet (5) and cable gland threaded coupling (6) onto the pre-terminated optical cable (1).
- Insert the split sealing grommet (5) into the cable gland threaded coupling (6).
- Set the SFP-module (3) into the socket until you hear a click.
- Insert the optical connector into the SFP-module (3).
- Screw the cable gland threaded coupling (6) into the port and tighten it.
- Tighten the cable gland nut (4). Do not apply excessive force.
| Note | ||
|---|---|---|
| ||
In order to disassemble SFP, please disconnect the optical cable, pull the clip of the SFP-module and withdraw the SFP-module from the slot. |