One link unit of link must be set to Master and the other one to Slave. At the link initial setup phase the following parameters must be set to the same values value on Master unit and Slave unit: - Center frequency - it may be set by two ways:
- Manually via "Downlink center frequency" and "Uplink center frequency" parameters. In this case wireless link will be setup at once.
- Automatically with "Automatic selection of center frequency" function. In this case frequency channel grids must be set on both units. At the initial phase Master unit will select its center frequency automatically from grid, after that Slave unit will scan frequencies from its grids grid and wireless link will be setup when Slave find the center frequency which Master operates on.
- Channel width - should be set manually on both units.
When a wireless link is established Slave unit will continuously inherit radio frontend parameters from Master unit excluding frequency channel grids. So, if you change some values on Master they will be set on Slave automatically. | 