High
- precision
mounting kit MONT-KIT-85PW is supplied with
device model Q70-39 by default.
It allows to make reliable and easy installation of the unit with two-axis adjustment. Packing List
Center |
---|
Gliffy Diagram |
---|
displayName | MONT-KIT-85PW Packing List |
---|
name | MONT-KIT-85PW _packing listPacking List |
---|
pagePin | 3 |
---|
|
|
Assemble Procedure
Step 1: Tighten the Assemble Assembled kit and Bracer to the pole using bolt M8, washer flat M8 and washer spring M8.
- Bolt M8x50 - used for installation on a pole with Ø 30 ... Ø 55 mm.
- Bolt M8x80 - used for installation on a pole with Ø 55 ... Ø 85 mm.
Step 2: Attach the ODU and Assemble kit using Insert and tighten the Assembled kit on the back side of the device using bolts M5x10, M5x16, washer washers flat M5 and washer washers spring M5.
Step 3: Perform required antenna alignment using adjustment knobs and then tighten nuts M8.
Note |
---|
|
Assemble kit is already adjust. In case you require additional adjustment, perform weaken on 1/8 turn using handles. After alignment tighten screws M5x10 and M5x16M8 nuts are pre-tightened at the manufacturing facility in a position that allows the device to be adjusted using the adjustment knobs and ensures that the wireless device does not shift during the final nuts tighten. |
Note |
---|
|
If further adjustment is required, weaken the nuts M8 on about 15 degrees. Do not adjust the knobs without weaken the nuts first. |
Center |
---|
Gliffy Diagram |
---|
displayName | MONT-KIT-85PW |
---|
name | MONT-KIT-85PW |
---|
pagePin | 14 |
---|
|
|
Mounting is carried out on a pole with a diameter 30 -... 85 mm. There are also possible options for mounting on a wall or pole with a diameter more than 85 mm.
Center |
---|
Gliffy Diagram |
---|
displayName | Pole mount_Q70 |
---|
name | Pole mount_Q70 |
---|
pagePin | 14 |
---|
|
|
Note |
---|
|
Clamps and other optional fasteners are not included in the Mounting mounting kit MONT-KIT-85PW. |