Cable Gland Assembly for RJ-45 connector
Required components are listed below.
- Unshielded RJ-45 connector.
- Shielded RJ-45 connector.
- FTP Cat5e cable.
- Cable gland:
- Cable sealing gland nut.Cable
- Split sealing grommet with rubber seal(with inner diameter 7 mm).
- Cable gland casethreaded coupling.
- Crimping tool for RJ-45 connector.
| Note |
|---|
|
The outside diameter value of the FTP Cat5e cable should not exceed 7 mm. |
| Note |
|---|
|
Cable gland can be assembled on pre-crimped cable. |
Assemble procedure
| Anchor |
|---|
| Assemble procedure |
|---|
| Assemble procedure |
|---|
|
In order to ensure that the device case remains sealed under any environmental conditions follow the assemble procedure:
- Step 1: Insert the sealing insert into the clamping claw.
- Step 2: Assemble the cable gland by putting the thread-lock sealing nut, clamping claw with sealing insert and body onto the cable as shown on the figure.
- Step 3: Insert the clamping claw with sealing insert into the body as shown on the figure.
- Step 4: Crimp the Crimp the standard RJ-45 connector onto the cable using crimping tool. Pin-out scheme: T568B wiring standardsstandard.
| Note |
|---|
|
Do not use the shielded RJ-45 connector on this end of the cable as it should be attached on the power supply unit end. |
| Warning |
|---|
|
Make sure that the RJ-45 connector is well-crimped. A loose connector can damage the device. Please note that such damage is not covered by the warranty. |
...
- Step 2: Assemble cable gland nut, the split sealing grommet and the cable gland threaded coupling onto the pre-terminated cable as shown on the figure below.
- Step 3: Insert the split sealing grommet into the cable gland threaded coupling.
- Step 4: Insert the RjRJ-45 connector into the device socket until you hear a click.
- Step 65: Screw the cable the cable gland body threaded coupling into the port and tighten it. Do not apply excessive force.
- Step 6: Tighten the cable gland nut (4). Do not apply excessive force.
Cable Gland Assembly for Optical Cable
Required components are listed below.
- Optical cable.
- Optical connector.
- SFP module.
- Cable gland:
- Cable gland nut.
- Split sealing grommet (with inner diameter 3.2 mm).
- Cable gland threaded coupling.
Assemble procedure
- Step 1: Put the cable gland nut, the split sealing grommet and cable gland threaded coupling onto the optical cable as shown on the figure below.
- Step 7: Tighten the thread-lock sealing nut. Do 2: Insert the split sealing grommet into the cable gland threaded coupling.
- Step 3: Set the SFP module into the socket until you hear a click.
- Step 4: Insert the optical connector into the SFP module.
- Step 5: Screw the cable gland threaded coupling into the port and tighten it.
- Step 6: Tighten the cable gland nut. Do not apply excessive force.
| Note |
|---|
|
In order to disassemble SFP, please disconnect the optical cable, pull the clip of the SFP module and withdraw the SFP module from the slot. |
| Note |
|---|
|
SFP module is not included into the packing list. |
| Center |
|---|
| Gliffy Diagram |
|---|
| displayName | Cable gland assy |
|---|
| name | cable assembling CopyCable gland assy |
|---|
| pagePin | 5 |
|---|
|
|