Cable Gland Assembly for RJ-45 connector
Required components are listed below.
- Unshielded RJ-45 connector.
- Shielded RJ-45 connector.
- FTP Cat5e cable.
- Cable gland:
- Cable gland nut.
- Split sealing grommet
- Cable gland threaded coupling.
- Crimping tool for RJ-45 connector.
| Note |
|---|
|
The outside diameter value of the FTP Cat5e cable should not exceed 7 mm. |
| Note |
|---|
|
Cable gland can be assembled on pre-crimped cable. |
Assemble procedure
| Anchor |
|---|
| Assemble procedure |
|---|
| Assemble procedure |
|---|
|
In order to ensure that the device case remains sealed under any environmental conditions follow the assemble procedure:
- Step 1: Crimp the standard RJ-45 connector onto the cable using crimping tool. Pin-out scheme: T568B wiring standard.
| Note |
|---|
|
Do not use the shielded RJ-45 connector on this end of the cable as it should be attached on the power supply unit end. |
| Warning |
|---|
|
Make sure that the RJ-45 connector is well-crimped. A loose connector can damage the device. Please note that such damage is not covered by the warranty. |
- Step 2: Assemble cable gland nut, the split sealing grommet and the cable gland threaded coupling onto the pre-terminated cable as shown on the figure.
- Step 3: Insert the split sealing grommet into the cable gland threaded coupling.
- Step 4: Insert the RJ-45 connector into the device socket until you hear a click.
- Step 5: Screw the cable gland threaded coupling into the port and tighten it. Do not apply excessive force.
- Step 6: Tighten the cable gland nut (4). Do not apply excessive force.
Cable Gland Assembly for Optical Cable
Required components are listed below.
- Optical cable.
- Optical connector.
- SFP module.
- Cable gland:
- Cable gland nut.
- Split sealing grommet.
- Cable gland threaded coupling.
Assemble procedure
- Step 1: Put the cable gland nut, the split sealing grommet and cable gland threaded coupling onto the pre-terminated optical cable.
- Step 2: Insert the split sealing grommet into the cable gland threaded coupling.
- Step 3: Set the SFP-module into the socket until you hear a click.
- Step 4: Insert the optical connector into the SFP-module.
- Step 5: Screw the cable gland threaded coupling into the port and tighten it.
- Step 6: Tighten the cable gland nut. Do not apply excessive force.
| Note |
|---|
|
In order to disassemble SFP, please disconnect the optical cable, pull the clip of the SFP-module and withdraw the SFP-module from the slot. |
| Note |
|---|
|
SFP module is not included in the packing list. |