Infinet Wireless: Technical Documentation
Page tree

Versions Compared

Old Version 3

changes.mady.by.user Tatyana Drazhnikova

Saved on

compared with

New Version 4

changes.mady.by.user Tatyana Drazhnikova

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Description

Perform a devices preliminary configuration consisting of the following steps:

  • Configure device ID.
  • Remove svi1 interface.
  • Assign IP addresses to network interfaces, according to the scheme.
  • Add static entries to the routing table.
  • Disable switching.
  • Set wireless links.
BS1
Code Block
languagetext
themeEmacs
ConfigureSet device ID
system prompt BS_1

Remove svi1 interface
ifc svi1 destroy

Assign IP addresses
ifc eth0 10.10.10.1/24
ifc rf5.0 172.16.0.1/29
ifc lo0 192.168.0.1/32

Disable switching
switch stop

Set wireless links
rf rf5.0 band 20
rf rf5.0 freq 5000

mint rf5.0 -name "BS_1"
mint rf5.0 -type master
CPE2
Code Block
languagetext
themeEmacs
ConfigureSet device ID
system prompt CPE_2

Remove svi1 interface
ifc svi1 destroy

Assign IP addresses
ifc eth0 10.10.20.2/24
ifc rf5.0 172.16.0.2/29
ifc lo0 192.168.0.2/32

Disable switching
switch stop

Set a wireless link
mint rf5.0 -name "CPE_2"
mint rf5.0 -type slave
mint rf5.0 prof 1 -band 20 -freq 5000 -type slave
CPE3
Code Block
languagetext
themeEmacs
ConfigureSet device ID
system prompt CPE_3

Remove svi1 interface
ifc svi1 destroy

Assign IP addresses
ifc eth0 10.10.30.3/24
ifc rf5.0 172.16.0.3/29
ifc lo0 192.168.0.3/32

Add static routes
route add 192.168.5.0/28 10.10.30.1
route add 192.168.6.0/28 10.10.30.1

Disable switching
switch stop

Set a wireless link
mint rf5.0 -name "CPE_3"
mint rf5.0 -type slave
mint rf5.0 prof 1 -band 20 -freq 5000 -type slave

...