The "Command Line" page emulates CLI (command line interface) in the Web interface. This allows managing and monitoring the device by using all the commands and functions that are available via standard CLI.
In order to run one or a set of WANFleX commands, type them in the command field and then click the «Execute» button. The output of the commands is displayed in the section above the command field:
| Center |
|---|
| Scroll Title |
|---|
| title-alignment | center |
|---|
| title | Figure - Command line |
|---|
|  Image Removed Image Added
|
|
In the "Command Line" menu, the commands are only executed, but not saved into the configuration. To execute the command and save it in the device configuration, while in "Extra commands" section from "Basic Settings" menu, the commands are executed and saved into the configurationuse the "config save" command.
| Warning |
|---|
|
After changing the configuration in the web interface, the commands that were previously applied through the CLI and are missing in the web interface will be lost. To add these commands use the "Basic settings" - "Additional commands" section. |