Page History

...

Step 1: Put Bolts M8x165 to its sockets, attach to the mast and assemble Bracers on the bolts. Put the Nuts M8 and Washers 8 (flat and spring) on the bolt without fastening.

...

Step 3: Use tightening torque of 16 Nm on the Nuts of Bolts M8x165 with 12.7 mm open end, or deep socket wrench. Tool's length should not exceed 20 cm.

Step 4: Use initial tightening torque of 10 Nm on Central bolts and Bolts M8x50(x2) and Azimuth Lock bolts (x4). Use 12.7 mm open end, or deep socket wrench.

Step 5: Screw the Elevation adjustment bolt to its position shown in the scheme#1 below.

Scheme#2

Scheme#2

Step 6: Use grease on marked recommended places (see scheme#2).

...

Step 8: Slide Elevation adjustment bolt dome head into it's slot on Antenna Dish Base.

Scheme#3

Step 9: Put Bolts M8x50 into their sockets and lock with Nuts M8 and Washers 8 (flat and spring) to initial tightening torque of 10 Nm.

Step 10: Screw Elevation adjustment bolt upward up to antenna horizontal position.

Scheme#4

Step 11: Screw Joint Lock bolts lock.

...

Step 13: After fine adjustment use tightening lock torque of 16 Nm on Azimuth Lock bolts and on Central bolts. Use tightening lock torque of 16 Nm on the Nuts of Elevation Lock bolts M8x50. Use 12.7 mm open end, or deep socket wrench.

...

Step 15: Adjustment bolts (Elevation and Azimuth) must be greased at all time.