In the "General Settings" section you may configure basic system parameters, described in the table below.
This section includes two main categories:
Unit
These parameters are used for identification and link authorization.
Parameter | Description |
---|---|
Device Name | The arbitrary wireless unit name which will be used by network administrators for unit identification. It will be shown in Web GUI side panel. |
Link ID | Wireless link identificator used to avoid connecting a unit to a wrong peer if there are several co-located units using the same center frequency. Specify different ID values for different links. Both ends of the same link must have the same ID. |
Access Key | Units at both ends of the wireless link should authorize each other before link establishment. Authorization is based on access keys:
|
Unit parameters description
Figure - Unit parameters
Account
TBD