The "Network settings" allows you to perform general networking configuration settings used for remote access to the unit.
The section is divided into the following categories:
Network interface
In this subsection you may configure one or more IP addresses of wired network interface. Each entry contains IP address, subnet mask and optional VLAN ID.
Click on "Add IP address" to add new entry. There are two configuration modes are available to obtain IP address: static and dynamic via DHCP. If you DHCP is enabled then IP address will be obtained automatically from available DHCP server. Otherwise you should set IP address and subnet mask values manually.
Default gateway may be configured in this subsection too.
Static routes
Allows you to configure the additional static routes by by specifying the destination network address, the network mask and the gateway for reaching the destination.
Click on "Add route" to add new entry.