The "General settings" section allows to configure basic system parameters, described in the table below.
This section includes two main csubsections:
Unit
These parameters are used for identification and link authorization.
| Parameter | Description |
|---|---|
| Device Name | The arbitrary wireless unit name which will be used by network administrators for unit identification. It will be shown in Web GUI side panel. |
| Link ID | Wireless link identificator used to avoid connecting a unit to a wrong peer if there are several co-located units using the same center frequency. Specify different ID values for different links. Both ends of the same link must have the same ID. |
| Access Key | Units at both ends of the wireless link should authorize each other before link establishment. Authorization is based on access keys:
|
Account
Here you may change system administrator account login and password.
NOTE
By default there is no login and password set. In security causes it's very important to set them before any configuration activities with the unit.
Regulatory domain
Regulatory domain automatically limits the wireless device operation which is may be needed to meet the local law requirements. Each regulatory domain may limits the following parameters:
- Range of available center frequencies
- Requirement of use LBT (Listen Before Talk) technique.
- Maximum EIRP (Equivalent Isotropically Radiated Power) value.
- Requirement of use radar detection technique.
