High-precision MONT-KIT-85PW is supplied with device by default. It allows to make reliable and easy installation of the unit with two-axis adjustment.
Packing List
- Assembled kit
- Bracer
- Bolt M5x10
- Washer flat M5
- Washer spring M5
- Bolt M8x50 (x2)
- Bolt M8x80 (x2)
- Washer flat M8 (x2)
- Washer spring M8 (x2)
Assemble Procedure
Step 1: Tighten the Assembled kit and Bracer to the pole using bolt M8, washer flat M8 and washer spring M8.
- Bolt M8x50 - used for installation on pole with Ø 30 ... Ø 55 mm.
- Bolt M8x80 - used for installation on pole with Ø 55 ... Ø 85 mm.
Step 2: Insert and tighten the Assembled kit into the ODU using bolt M5x10, bolt M5x16, washers flat M5 and washers spring M5.
Step 3: Assembled kit is already have factory adjustment. In case you require additional alignment perform it using adjustment knobs, after that tighten nuts M8.
NOTE
If further adjustment is required, weaken the nuts M8 on about 15 degrees. Perform required antenna alignment using adjustment knobs and then tighten nuts M8.
Do not adjust the knobs without weaken the nuts first.
Mounting is carried out on a pole with a diameter 30 ... 85 mm. There are also possible options for mounting on a wall or pole with a diameter more than 85 mm.
NOTE
Clamps and other optional fasteners are not included in the Mounting kit MONT-KIT-85PW.