InfiNet Wireless R5000 series units can be configured via Web interface, or via Command-line interface.
The parameters for the majority of the Command-line interface commands are displayed in the Web interface. Saving the configuration for these parameters in any of the two interfaces (Command-line and Web) is reflected in both interfaces.
However, for some other commands, the most important parameters can be set via Web interface, but the enhanced parameters of these commands can be set via Command-line interface only. The commands that do not have the enhanced parameters displayed in Web interface are: sys, ifconfig, prf, qm, tun, route, mint, switch, svi, lag, sntp, dhcpc (please consult the information about the Extra Commands section within the current chapter, below).
The settings of these enhanced parameters will be lost after saving the configuration via Web interface.
The warning message below is displayed in the "Basic Settings" page from the Web interface if the configuration has been previously created via CLI, in order to avoid losing data for those only few commands that don’t reflect their parameters in the Web interface:
NOTE
This message is not displayed in the default configuration, but only after the first configuration via CLI.
The "Basic Settings" page has the following sections: