Infinet Wireless: Technical Documentation
Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Успешно сдайте бесплатный сертификационный экзамен в Академии "Инфинет" и получите статус сертифицированного инженера Инфинет.

Пройти сертификационный экзамен

Сборка кабельного ввода для разъема RJ45

Для сборки вам потребуются следующие компоненты:

  1. Стандартный разъем RJ-45.
  2. Экранированный разъем RJ-45.
  3. Кабель FTP Cat5e.
  4. Кабельный ввод:
    • Гайка кабельного уплотнения.
    • Втулка с резиновым уплотнением.
    • Корпус разъема.
  5. Обжимные клещи для разъема RJ-45.

NOTE

Значение внешнего диаметра кабеля FTP Cat5e не должно превышать 7 мм.

NOTE

Cable gland can be assembled on pre-crimped cable.

Assemble procedure 

In order to ensure that the device case remains sealed under any environmental conditions follow the assemble procedure:

  • Step 1: Crimp the standard RJ-45 connector onto the cable using crimping tool. Pin-out scheme: T568B wiring standard.

NOTE

Do not use the shielded RJ-45 connector on this end of the cable as it should be attached on the power supply unit end.

CAUTION

Make sure that the RJ-45 connector is well-crimped. A loose connector can damage the device. Please note that such damage is not covered by the warranty.

  • Step 2: Assemble cable gland nut, the split sealing grommet and the cable gland threaded coupling onto the pre-terminated cable as shown on the figure below.
  • Step 3: Insert the split sealing grommet into the cable gland threaded coupling.
  • Step 4: Insert the RJ-45 connector into the device socket until you hear a click.
  • Step 5: Screw the cable gland threaded coupling into the port and tighten it. Do not apply excessive force.
  • Step 6: Tighten the cable gland nut (4). Do not apply excessive force.

Cable Gland Assembly for Optical Cable

Required components are listed below.

  1. Optical cable.
  2. Optical connector.
  3. SFP module.
  4. Cable gland:
    • Cable gland nut.
    • Split sealing grommet (with inner diameter 3.2 mm).
    • Cable gland threaded coupling.

Assemble procedure

  • Step 1: Put the cable gland nut, the split sealing grommet and cable gland threaded coupling onto the pre-terminated optical cable as shown on the figure below.
  • Step 2: Insert the split sealing grommet into the cable gland threaded coupling.
  • Step 3: Set the SFP module into the socket until you hear a click.
  • Step 4: Insert the optical connector into the SFP module.
  • Step 5: Screw the cable gland threaded coupling into the port and tighten it.
  • Step 6: Tighten the cable gland nut. Do not apply excessive force.

NOTE

In order to disassemble SFP, please disconnect the optical cable, pull the clip of the SFP module and withdraw the SFP module from the slot.

NOTE

SFP module is not included into the packing list.

  • No labels