The device can be configured via:
Console port
The device is equipped with an RJ45 console port to connect PC for configuration and management. In order to configure the device using console port, follow the below:
- Connect the console port to the PC serial port with the console cable.
- Check the PC serial port number. To do this, go to "Device Manager" → "COM and LPT ports". The drivers installation may be needed.
- Run any terminal emulation program (for example, PuTTY: https://www.putty.org/).
- Select the serial port.
- Go to the serial connection settings section, set the port characteristics to 38400 rate, 8 bits, 1 stop bit, parity off, flow control is disabled, and click "Open".
If all above procedures are completed correctly, you will see the WANFleX OS prompt:
- Login.
- Password
Every new device has no initial login and password settings, so you can use any non-zero length login and password to enter the device.
After default authorization there will be standard console prompt: "console>". Now the device is ready for the initial configuration procedure.