...
- "Chain #0" is connected to the port of the vertical horizontal polarized integrated antenna (H-port for connectorised models)
- "Chain #1" is connected to the port of the horizontal vertical polarized integrated antenna (V-port for connectorised models)
Center | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
If the "Single" mode is selected when, then "Chain #1" column (horizontal vertical polarization) can be disabled for transmission (TX) and / or reception (RX):
...
The data streams are transmitted over Chain #0 (corresponding to vertical horizontal polarization) only, lowering the performance of the link, but increasing the link distance (transmitter operates with one antenna as does the receiver; there is no diversity and no additional processing for recomposing the Rx signal):
Center | |||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Warning | ||
---|---|---|
| ||
In case of establishing the link in Compatibility Mode, please note that R5000 devices have different the vertical and horizontal polarization correspondence to Chain #0 and Chain #1 channels. For R5000 devices:
|
The picture below summarizes the link establishment between two units that are configured in different operational modes. As it can be noticed, only the combination MIMO – SISO is not functional.
...