Infinet Wireless: Technical Documentation
Page tree
Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Figure - AUX-ODU-INJ-G

Optional indoor/outdoor DC injector with built-in lightning protection. It greatly reduces complexity of the deployment in the cases where DC source is available on the rooftop eliminating the need of weather-sealed cabinets.

ParameterDescription
Size and Weight34x94x121 mm, 0.28 Kg
Connectors and Interfaces
  • ETH IN - Ethernet input
  • ETH OUT - Ethernet output (data+VDC, protected leg)
  • PWR - DC Input
  • GND - Ground clamp
Supported Ethernet Modes
  • 10/100/1000 Mbps (Gigabit Ethernet pass-through)
Water and Dust Protection
  • IP66 and IP67
Operating temperature range
  • -55 °C ... +60 ºC
DC Range
  • Xm, Um (InfiLINK XG)
  • R5000-Mmx, R5000-Omx (InfiNet Wireless R5000)

±43...±56 VDC 

  • R5000-Smn, R5000-Lmn (InfiNet Wireless R5000)

+9... +56 VDC (positive voltage only)

CAUTION

Using inappropriate DC source will damage the ODU, which will be not covered by warranty

Ethernet Connectors Pin-out

ETH IN:

PinDescription
1Data pair A+
2Data pair A-
3Data pair B+
4Data pair C-
5Data pair C+
6Data pair B-
7Data pair D+
8Data pair D-

ETH OUT:

PinDescription
1Data pair A+
2Data pair A-
3Data pair B+
4+VDC + Data pair C-
5+VDC + Data pair C+
6Data pair B-
7-VDC + Data pair D+
8-VDC + Data pair D-
Lightning Protection

In compliance with:

  • GR-1089
  • IEC 61000-4-2 (ESD) 15kV (air), 8kV (contact)
  • IEC 61000-4-4 (EFT) 40A (tp = 5/50ns)
  • IEC 61000-4-5 (Lightning) L5, 95A (tp = 8/20us)
  • ETSI ETS 300 386
Table - AUX-ODU-INJ-G Specifications
  • No labels