sys uptime
Displays the system up time since the last reboot and the reason of this reboot.
Figure - "sys uptime" command output
The possible options are:
- Software fault
- Unexpected restart
- Manual restart
- Manual delayed restart
- Firmware upgrade
- SNMP managed restart
- Test firmware loaded.
sys log show
Displays the unit event log.
sys info -full
Displays the detailed information about:
- System
- Memory
- CPU
- Flash
- DFFS
- License
- PHY0
- PHY1.
Figure - "sys info -full" command output
config show
Displays the current unit configuration.
ifconfig -a
Displays the detailed information about network and radio interface.
Figure - "ifconfig -a" command output
license -show
Displays options available in this license
Figure - "license -show" command output
ctl
Displays the switch board temperature.
Figure - "ctl" command output
tsync
Displays the synchronization statistics via built-in GLONASS/GPS receiver.
ptpd
Displays the synchronization statistics via IEEE 1588 PTP.
mem
Displays the memory utilization statistics.
Figure - "mem" command output