Attention
Configurations from the scenarios below are examples that demonstrate the potential capabilities of Infinet devices. The configuration may change depending on the model and firmware version. Do not recommend copying the solution data to the hardware without checking.
Description
The maximum throughput of a single port is limited to the standard 100Base-TX. The throughput of the radio module depending on the MCS and the channel width can be higher. R5000 devices of Lite series can achieve the maximum throughput up to 180 Mbps of the bi-directional aggregated stream. It is not possible to use the maximum throughput of the radio channel in one direction through one 100Base-TX port. However, the combination of ports into one LAG allows achieving the maximum throughput in one direction.
Conceptual PtP scheme
Also, this scenario can be used in point-to-multipoint topologies.
Conceptual PtMP scheme
Configuration via GUI
- Create LAG interface
- Add ports
Choose LACP (Standard or Fast mode). "Standard" LACP fully complies with the standard IEEE 802.3ad. “Fast” LACP uses only with Infinet devices and increases efficiency and performance compared default mode.
Attention
The "Fast" mode is a proprietary extension of the LACP protocol. Compatibility of this mode is guaranteed only with devices that support the MINT protocol.
- Configure management IP for LAG interface or SVI (optionally)
- Configure switch group
Configuration via CLI
lag N [command] [(port|-port) (IFNAME | IFNAME...)]
Command | Description |
---|---|
lag N port (IFNAME | IFNAME...)] | Create LAG with name “lagN” and add ports |
lag N status | Check the status of LAG with name “lagN” |
lag N migrate lag N -migrate | Allow/disallow existing sessions migration between the available parent interfaces in case of the difference in the overload. By default, migration is allowed |
lag N balance lag N -balance | Allow/disallow load-depending dispersion of new-coming sessions between the available parent interfaces. By default, balancing is enabled |
lag N mode | Choose LACP (Standard or Fast mode). "Standard" LACP fully complies with the standard IEEE 802.3ad. “Fast” LACP uses only with Infinet devices and increases efficiency and performance compared default mode Attention The "Fast" mode is a proprietary extension of the LACP protocol. Compatibility of this mode is guaranteed only with devices that support the MINT protocol. |
lag N clear | Delete LAG with name "lagN" |
lag N loadm | Show a load statistics in real time on each of the parent interfaces |
Example
The basic configuration of Link Aggregation. The configuration via GUI is described above.
Configuration via CLI:
Create LAG
Creating LAGlag 0 port eth0 eth1 ifc lag0 up
Configure management IP for a LAG interface or SVI (optionally)
Creating Managmentifc lag0 10.10.10.1/24
Configure switch group
Creating Managmentswitch group 1 add 2 rf5.0 lag0 switch group 1 start