The "General settings" section allows to configure basic system parameters, described in the table below.
...
These parameters are used for identification and link authorization.
| Center |
|---|
| Scroll Title |
|---|
title | Unit parameters description |
|---|
| Parameter | Description |
|---|
| Device |
| name | The arbitrary wireless unit name which will be used by network administrators for unit identification. It will be shown in Web GUI side panel. |
| Link ID | Wireless link identificator used to avoid connecting a unit to a wrong peer if there are several co-located units using the same
| Center |
|---|
frequency. Specify different ID values for different links. Both ends of the same link must have the same ID. |
|---|
| Center |
|---|
| Scroll Title |
|---|
| title | Figure - Unit parameters |
|---|
|  Image Removed
|
|
Regulatory domain
Regulatory domain automatically limits the wireless device operation which is may be needed to meet the local law requirements. Each regulatory domain may limits the following parameters:
- Range of available center frequencies
- Requirement of use LBT (Listen Before Talk) technique.
- Maximum EIRP (Equivalent Isotropically Radiated Power) value.
- Requirement of use radar detection technique.
| Center |
|---|
| Scroll Title |
|---|
| -alignment | center |
|---|
| title | Figure - Regulatory domain settings |
|---|
| Image Removed |  Image Added
|
|
SNTP
Starts the SNTP time synchronization service. For proper operation, specify the SNTP server time zone and the IP address first. By default, the SNTP service is disabled.
| Center |
|---|
| Scroll Title |
|---|
|
| title | SNTP parameters description |
|---|
|
Server Addressserver address
| The SNTP server IP address, the SNTP service will synchronize the time on the device with. The device must have network access to the SNTP server. |
| Time |
zone
| The time zone at the place of device installation. For example: GMT + 5. |
| Center |
|---|
| scroll-title |
|---|
| title-alignment | center |
|---|
| title | Figure - SNTP settings |
|---|
| 
|
|
Syslog
Allows to transmit syslog data to the server using the "syslog" protocol. Specify the syslog server address where data should be transmitted.
| Center |
|---|
| Scroll Title |
|---|
| title-alignment | center |
|---|
| title | Figure - Syslog configuration |
|---|
|  Image Added
|
|